| Technical data/ Configurator |
|
|
High-Speed Router Spindle
The high speed router spindle
is designed for router shaft diameters of
Ø ¼”–⅝” (6–16 mm) and a speed of
16,000 rpm.
|
|
|
The renowned FELDER 500 saw assembly
Stable and compact saw unit built to last:
- Cutting height of 4” with a 12” (315 mm) blade
- Double-sided support
- Smooth tilting action 0°–45°
- Support close to the saw blade on both sides
|
|
|
Precision sliding table-Guiding system “X-Roll”.
“X-Roll” makes a difference:
- Extremely smooth and precise sliding action! With the roller-bearing system there is no single point of contact
between bearings and guiding track, maximizing precision over the lifetime of the machine.
- Clean, dust-free guide rails obtained by special wipers and brushes.
- Smooth movement of the sliding table ensured by hardened steel, ground-bearing tracks.
- 6-year-warranty
|
|
|
crosscut fence
The crosscut fence 51” (1300 mm) for crosscuts between +45° and –45°. The fence can be attached to the sliding table with out the use of tools. The end stop provides you with the exact 90° position.
|
|
|
Stop scale
The bevelled miter scale with hairline readout is visible from the operating area and thus allows exact reading of the required crosscut value.
|
|
|
The renowned FELDER “500” Shaper assembly
Stable and compact spindle unit for long lasting precision
- Maximum tooling above the table 4” (100 mm)
- Table opening 7” (180 mm)
- 4 speeds 3000, 6000, 8000, 10,000 rpm
- 14,000 rpm high speed router spindle in place of the shaper spindle.
(must be ordered before the machine is produced).
- Smooth rearward tilt to 45°
- Height adjustment with cast iron segment
|
|
|
Tennoning and slotting
The highest accuracy is assured for standard shaping work and when using large cutters for tenoning with Felder shapers.
|
|
|
Tilt Bracket
The Felder device for tilting the feeder away means the power feeder always remains on the machine and can be used at any moment without problems.
|
|
|
Scoring unit
For the professional processing of sheet material the saw can be equipped with the independently adjustable scoring unit.
|
|
|
rip fence
The rip fence is easily and smoothly adjustable, with a one-hand clamping mechanism.
The fine adjustment mechanism allows for precise measurements.
A rip capacity of 31½" (800 mm) comes standard with the option of upgrading to a rip capacity 49¼" (1250 mm). The rip scale is easy to read and perfectly integrated into the machine body.
|
|
|
Shaper fence “220”
Shaper fence ”220“ for max.
tooling diameter 220 mm (8½”)
|
|
|
The Felder rearward tilting spindle is the correct way for easy and safe operation:
- Safety, since there is no pinch point
- No limitations on work piece height
- Problem free power feeder operation
- Impeccable workpiece finish
- Optimal chip removal
|
|
|
Dado
The Felder 500 Series saw assembly is fully compatible with dado tooling. Thanks to a removable table insert and flanges, specialized Felder dado tooling can be used.
|
|
